How Much Does It Cost to Replace a Sump Pump?
Your sump pump is your first line of defense against flooding, directing water away from your home and saving you from costly water damage repairs.
When it breaks down, you want to replace it immediately. But the cost is a concern for many homeowners.
Keep reading to find out about sump pump replacement costs and ways to save. And if you’ve already experienced plumbing problems, call All Dry USA to get emergency repairs.
How Much Does a Sump Pump Replacement Cost?
The replacement cost can vary depending on the quality and type of sump pump. The typical price ranges from $400 to $600, with homeowners paying a little under $500 on average. If you do it yourself, you could pay less than $300.
The cost may surprise you if you’ve installed a new sump pump before, but rest assured, you didn’t get taken advantage of in installing new equipment. The cost of replacing your sump pump vs. installing one differs significantly. Installation usually runs over $1000 on average. However, the general rule is that replacing existing equipment is more cost-efficient than installing a completely new one.
When fitting a replacement, it simply requires less labor. The plumbers will have already dug the reservoir during the initial installation. Plus, the drainage is already in place. It makes a replacement much simpler and cheaper.
Understandably, spending a few hundred on replacement may be concerning. Still, it’s worth it to replace your equipment ASAP. Sump pumps can make the difference between a dry home and a flooded one.
Not only that, but the dangers of flooding can pose a risk to your health and safety. Sump pumps protect you from floods and various home and health risks.
Sump Pump Replacement Cost Breakdown
Don’t be discouraged by initial quotes. After all, they’re full of variables. Some factors impact the price of your replacement, and these are also areas where you can save.
What Is the Labor Cost to Install a Sump Pump?
If the job appears straightforward, with minimal digging or additional work required, the cost will likely be towards the lower end.
However, if the job looks intensive, requiring further digging or movement of the installation, then the service providers will price the job higher. Some contractors charge per hour for their work, so ask for a definitive time estimate. Others charge by the job, so your price will stay the same unless they uncover something unknown in the first estimate.
The average labor price for installation is $1000.
The size and condition of your home can also play a part in the final price. If the area is difficult to access, it could cost you more.
Type of Sump Pump
There are two types of sump pumps, each priced differently.
Pedestal Sump Pump
Prices here range from $60 to $170. These are cheaper than their counterparts because they are easier to access since they’re not in the pump basin.
This pump sits on the floor, like the basement or crawlspace. The location offers easy access for service providers, which saves on costs. It also makes it easier to check the equipment and maintain it.
Submersible Sump Pump
Prices here range from $60 to $420. They can be more expensive than the pedestal pumps because they offer you more. They save space, offer more power, and can have battery backups.
Submersible pumps work by submersion, which prevents their motor from overheating. They are entirely underwater in the sump basin. Plumbers typically install this type when a house is first under construction.
How to Save Money on a Sump Pump Replacement
According to the National Flood Service, water damage can set you back $3.75 per square foot, and that’s only a category one flood with clean water. The price increases with more contaminated water, making a sump pump a smart investment.
The good news is there are ways that you can reduce the cost and save yourself some money while continuing to protect your home from flooding:
- Regularly check your pump’s position. Did you know that vibrations from the inner mechanisms can move your pump and shift its position? Every so often, check that the equipment is still upright and adjust as necessary.
- Test your pump. To do this, just pour some water into the pit so you can see yourself if your equipment is running correctly. Doing this several times a year will suffice.
- Keep your pump clean. Debris can get trapped in the mechanisms, especially the inlet screen. Clear it out every 3 – 4 months.
- Invest in a filter. Less clogged debris in your inlet screen will extend your product’s lifespan.
Frequently Asked Questions
How Long Does a Sump Pump Usually Last?
If you take sufficient care of your sump pump, the system will run longer. The potential for a basement pump lifespan is 10 to 15 years, depending on the type. Pedestal sump pumps have a longer lifespan, from 10 to 20 years. The submersible sump pump has a shorter lifespan, from 5 to 10 years.
If the motor is maintained correctly, it can continue running for 20 to 25 years. Maintenance is vital even if you have a battery backup solution.
How Do I Know When It’s Time for a Replacement Sump Pump?
Watching out for the signs of a degrading pump is vital. Catching an issue earlier rather than later may help lower the cost of future repairs. Here are some signs to watch out for:
- Frequent power cuts
- A failing motor
- Loud, unusual noises from the motor
- Noticeable rust
- Infrequent cycling
If your sump pump has stopped working altogether, then, of course, it’s time to replace your pump.
Is It Easy to Replace a Sump Pump?
Any work on your plumbing could seem like a long task because it’s an integral part of the home. Replacing sump pumps is straightforward. A homeowner could take on the job themselves, but if you want a running, operational system that lasts, call the professionals.
Make sure your sump pump is the correct size for the sump basin in your home and appropriate to the size of your basement. Professionals can advise you here.
Experienced Plumbing Problems? Call Us!
Stay prepared, watch out for any malfunctions occurring with your pump, and deal with issues sooner rather than later. And remember, if you need a professional, call us. All Dry USA is an expert in water damage repair, plumbing, leaking detection, and more. If you’ve experienced plumbing problems, call us!